Universal Decoder 1131
The Universal Decoder 1131 is freely programmable in terms of both its receiving address and its outlet switch time, and a special programming mode is incorporated in control centres with software version V2.12. and above for this purpose. The outlet switch times can be selected from 10 speeds from 0.2 seconds right through to continuous operation. Continuous operation is intended for use with the direct connection of light signals, thus four of the eight outlets are always active in this operating mode. The eight outlets are assigned to four pairs of address outlets. In continuous operation, the odd outlets are active (always the left-hand connector when connectors are lying upwards) in the home position (that is, after switching on the power supply) = stop (red).
For direct connections of motor-operated point mechanisms, switch times of 0.2 to 15 seconds can be programmed for the changeover time, thus eliminating the need for additional relay modules and their extra wiring. For motor-operated point mechanisms we offer the type 1132 / 1032 specialized for this using
The Switch-to-Ground Prinzip is to make it possible to use external power with higher voltage (up to 24V DC) for more powerfull switching and saving power from the trackswitch voltage source.
Customers who bought this product also bought the following products:
![]() |
4000 Trackswitch ID ManagerThe ID Manager is used for writing, testing und reading transponders. Transponders are available in the form of self-adhesive paper or foil, similar to a lable. These transponders are ideal for use on model railways. But this technology is also ideally suited for cataloguing, marking and marking various objects in collections. Suitable transponders can also be obtained from us. With the ID Manager, such transponders (IEC 14443) can be written with a four-digit number. These restriction to four digits result from the possibility of the display module 9086 to display only four-digit numbers. This means that it is possible to distinguish between 10.000 (0000 to 9999) different objects (locomotives, wagons etc.). Transponders can be rewritten as often as required. With the exception of metal, transponders can be read or writtten through all materials up to a thickness of 8-10mm. 56,50 EUR (19 % VAT incl. excl. Shipping costs) |
![]() |
4010 read moduleRead modul consisting of two components. Antenna board and reading electronics, connected with enclosed cable. Mounted under a model railway track, it is used to read out RFID transponders quided over it. Range up to 30mm. Read-out data are output via the Trackswitch feedback bus either to the Trackswitch control panel, to a display module 9086 directly with cable 8030 (2m, other lengths possible) or via an adapter cable to any S88 feedback system. 29,60 EUR (19 % VAT incl. excl. Shipping costs) |
![]() |
Module 9030 Signal module for right-hand traffic. Green / Red - signal pictureModule 9030 Signal module for right-hand traffic. Green / Red - signal picture |
9050 Accessory shoe 100 Pieces9050 Accessory shoe 100 Pieces |
|
![]() |
Module 9071 Module for set of points for the Rail occupied illumination, 45° with red long field luminous diodeModule 9071 Module for set of points for the Rail occupied illumination, 45° with red long field luminous diode |
![]() |
Module 9010 Line aheadModule 9010 Line ahead
|
This Product was added to our catalogue on Friday 27 February, 2015.