Deutsch English

Module 9010 Line ahead

Module 9010 Line ahead
Zoom image

1,35 EUR

19 % VAT incl. excl. Shipping costs

Shipping time: 3-4 Days

Product no.: 9010
Module 9010 Line ahead

Module 9010

Line ahead

 

 

Customers who bought this product also bought the following products:

4010 read module

4010 read module

Read modul consisting of two components. Antenna board and reading electronics, connected with enclosed cable. Mounted under a model railway track, it is used to read out RFID transponders quided over it. Range up to 30mm. Read-out data are output via the Trackswitch feedback bus either to the Trackswitch control panel, to a display module 9086 directly with cable 8030 (2m, other lengths possible) or via an adapter cable to any S88 feedback system.

29,60 EUR (19 % VAT incl. excl. Shipping costs)
9086 Display module

9086 Display module

Four-digit display module for installation in the Digimoba track control panel. Can also be integratet into other track control panel systems (selfmade). Used in conjunction with the reader module 4010 to display four-digit transponder numbers, Thus the position of a certain vehicle or whole train (train number) can be unmistakably in the track diagram.

33,50 EUR (19 % VAT incl. excl. Shipping costs)
Module 9026 Y point  symbol with 2 push button light-emitting diodes

Module 9026 Y point symbol with 2 push button light-emitting diodes

Module 9026

Y point  symbol with 2 push button light-emitting diodes

 

12,00 EUR (19 % VAT incl. excl. Shipping costs)
Track Module 2024 for two-wire DC, analogue, specifically for block operation

Track Module 2024 for two-wire DC, analogue, specifically for block operation

Track Module 2024 for two-wire DC, analogue, specifically for block operation

Anyone who has built electronic modules for controlling starting and braking into their system before is familiar with a particular problem – while one train reaches its precise stopping point, a second stops hugely short of it and a third even continues at such a speed that it overshoots the mark entirely or halts abruptly! Regardless of what control attempts are made, nothing is 100% suitable for all vehicles! This is the result of the varying driving characteristics of each of the individual traction units. Therefore, we have developed a track module with speed-regulated delay. By measuring the approaching train, the slow speed during deceleration is set. In this way, faster trains are decelerated more, whereas slower trains are decelerated to a lesser extent, thus allowing each train to arrive at its intended target.

This microprocessor-controlled module functions using pulse width control. 64 speeds are available. It is specifically for use in block sections and is controlled by the input for occupancy indication for the next track section or ground potential (=free) in connection with the three built-in track occupied indicators.

For use in block sections, single- and double-track, without influence in opposite direction. Aside from the occupancy indicator outlets for all three individual sections, there is also an overall occupancy indicator outlet for switching multiple track component 2024s in a row in automatic block section operation or for feedback via feedback modules 1051 and 1151. In addition to this, a light block signal can also be attached. As such, this compact device enables complete and independent block control. One 2024 module is required per block section.

Transit in the opposite direction at a red signal is possible and occurs without influencing the train.

Requires a traction current source (max. 12V=) and an adjunct current supply (16V~ or =) to operate.

Also available without casing at a lower price as 2124.

 

51,10 EUR (19 % VAT incl. excl. Shipping costs)
Universal Decoder 1131

Universal Decoder 1131

Universal Decoder 1131

The Universal Decoder 1131 is freely programmable in terms of both its receiving address and its outlet switch time, and a special programming mode is incorporated in control centres with software version V2.12. and above for this purpose. The outlet switch times can be selected from 10 speeds from 0.2 seconds right through to continuous operation. Continuous operation is intended for use with the direct connection of light signals, thus four of the eight outlets are always active in this operating mode. The eight outlets are assigned to four pairs of address outlets. In continuous operation, the odd outlets are active (always the left-hand connector when connectors are lying upwards) in the home position (that is, after switching on the power supply) = stop (red).
For direct connections of motor-operated point mechanisms, switch times of 0.2 to 15 seconds can be programmed for the changeover time, thus eliminating the need for additional relay modules and their extra wiring.
For motor-operated point mechanisms we offer the type 1131 specialized for this using

 

The Switch-to-Ground Prinzip is to make it possible to use external power with higher voltage (up to 24V DC) for more powerfull switching and saving power from the trackswitch voltage source.

43,30 EUR (19 % VAT incl. excl. Shipping costs)
Starter Kit 1002B

Starter Kit 1002B

Starter Kit 1002B

This set contains everything you need in order to operate Trackswitch in a model railway system. The decoder 1132 (included in the set) is ideally suited to use with motorised point mechanisms. Up to 4 point mechanisms can be connected and these are especially protected by the decoder. Addresses and output circuit times can be programmed. It therefore plays no role whether or not the point machines are fitted with functional limit stops. The power supply is provided from the Trackswitch centre via the switch decoder bus line (1m, also enclosed). As such, the centre ensures the serial activation of the operators – that is, only one operator is ever switched at one time – thus maintaining a low current load on the power supply.

 For using Trackswitch, Signal box, switch commands, indication controls, shadow station controls, commuter train controls, turnaround loop controls,

237,60 EUR (19 % VAT incl. excl. Shipping costs)

This Product was added to our catalogue on Wednesday 04 March, 2015.

[<Back] | [Overview] | [Next>] | [last>>] | Product 2 of 50 in this category

Shopping cart

You do not have any products in your shopping cart yet.

Welcome back!

E-mail address:
Password:
Forgot your password?

Newsletter subscription

E-mail address:

Customer group


Customer group: Guest

Manufacturer information

Digimoba Elektronic
Digimoba Elektronic
More products

Manufacturer

Parse Time: 0.107s