The three way point Mudule in 2070

Module 9032 Signal module for right-hand traffic. Green / Red / Yellow signal picture

Module 9032

Signal module for right-hand traffic. Green / Red / Yellow signal picture

Module 9080 Module for set of points, straight distance symbol with 2 yellow long field luminous diodes

Module 9080

Module for set of points, straight distance symbol with 2 yellow long field luminous diodes

Module 9081 Module for set of points, 45° with yellow long field luminous diode

Module 9081

Module for set of points, 45° with yellow long field luminous diode

Module 9082 Module for set of points, 45° parallel, with 2 yellow long field luminous diodes

Module 9082

Module for set of points, 45° parallel, with 2 yellow long field luminous diodes

Module 9085 Module for set of points, combined Rail occupied illumination with seaway illumination

Module 9085

Module for set of points, combined Rail occupied illumination with seaway illumination

Drive Controller 2030 for two-wire DC tracks, analogue

Drive Controller 2030 for two-wire DC tracks, analogue

This electronic drive controller was specially developed for use in track control panels and is suitable for all two-wire DC track systems. With the appropriate power supply from a suitable AC transformer of approximately 16-20V and at least 25VA, a maximum current of ca. 1,2A can be drawn.
Operation is very simple. The potentiometer delivered with the module is the only operating control. The neutral position of the drive controller is equivalent to the potentiometer’s middle setting. By twisting the control button to the left or right, the traction vehicle is driven in the respective direction. This occurs with pulse width-controlled traction current, as a result of which unimaginable, delicate manoeuvres are possible, especially in the go slow area! By means of a setting controller attached to the front side of the electronic component, start/ brake delays can be set, in order to achieve a mass simulation of the train being controlled. This can, of course, also be set to neutral – that is, without delay.
The LEDs delivered with the module display the respective direction of travel. Only in neutral position (control button in middle position) are both off. In the event that the integrated electronic overload protection is activated, the traction current is switched off and both LEDs flash. Only once the cause of the overload has been eliminated and the controller has been set to neutral does the flashing cease and the traction current is switched on again.
The set contains all components required for assembly with the track control panel. The potentiometer is suitable for assembly with a blank module from the Digimoba signal box system. When assembling the module with other track control panels, please note the maximum thickness of the supporting material of 4mm!