Module 9011 Line symbol 45°

Module 9011

Line symbol 45°

Module 9012 Line symbol 45° parallel

Module 9012

Line symbol 45° parallel

Relay Module 2111 without case

Relay Module 2111 without case

The relay module houses 2 independently usable two-state relays each with two switch contacts. Each circuit in a relay is capable of carrying up to 2A and is designed for a maximum switching current of 24V. The relay is triggered by a negative impulse (ground). The position of each relay is retained even once the voltage has been switched off. Place and position of installation are uncritical. In addition to direct current voltage between 12 and 18V, this relay module can be operated with 16V alternating current voltage.
Available with casing as 2011 or, at a lower price, without casing as 2111.

Universal Decoder 1131

Universal Decoder 1131

The Universal Decoder 1131 is freely programmable in terms of both its receiving address and its outlet switch time, and a special programming mode is incorporated in control centres with software version V2.12. and above for this purpose. The outlet switch times can be selected from 10 speeds from 0.2 seconds right through to continuous operation. Continuous operation is intended for use with the direct connection of light signals, thus four of the eight outlets are always active in this operating mode. The eight outlets are assigned to four pairs of address outlets. In continuous operation, the odd outlets are active (always the left-hand connector when connectors are lying upwards) in the home position (that is, after switching on the power supply) = stop (red).
For direct connections of motor-operated point mechanisms, switch times of 0.2 to 15 seconds can be programmed for the changeover time, thus eliminating the need for additional relay modules and their extra wiring. For motor-operated point mechanisms we offer the type 1131 specialized for this using

The Switch-to-Ground Prinzip is to make it possible to use external power with higher voltage (up to 24V DC) for more powerfull switching and saving power from the trackswitch voltage source.

Feedback Module 1151 without case

Feedback Module 1151 without case

Specifically developed in accordance with modern model railway system requirements. Each feedback module has 8 isolated inlets, electrically separated from the electronic system by optocouplers. The feedback module is connected to the centre 1000 or 1100 using a separate 6-pin cable with modular plugs (8015-19). The feedback modules are simply connected in a row and so can be expanded to up to 32 modules. Thus, up to 256 feedback signals can be fed in. This includes in particular line occupied signals, track switches, track contacts, point position feedback signals, timers, switch keys and other switching operations. Switch keys can also be connected within the signal box for some specific applications (e.g. for track splitting, for operating special edition models and working models, etc.), in order to activate defined processes and automatic mechanisms. These are specified in advance in the central unit ‘Trackswitch’.

Module 9085 Module for set of points, combined Rail occupied illumination with seaway illumination

Module 9085

Module for set of points, combined Rail occupied illumination with seaway illumination